RE: iSCSI: FirstBurstSize and unsolicited data

["Julian Satran" <Julian_Satran@il.ibm.com>]

... or all the data - if it is less than the FirstBurstSize. Julo

Sanjay Goyal <sanjay_goyal@ivivity.com> Sent by: owner-ips@ece.cmu.edu 06/14/2002 04:37 PM Please respond to Sanjay Goyal

To:        "'Nandakumar Ramamurthy'" <nramamur@npd.hcltech.com>, ips@ece.cmu.edu         cc:                 Subject:        RE: iSCSI: FirstBurstSize and unsolicited data

The specifications says
 If you send any non-immediate unsolicited data-out PDUs, the total
unsolicited amount of data should be FirstBurstSize amount of data.


Regards
Sanjay Goyal


-----Original Message-----
From: Nandakumar Ramamurthy [mailto:nramamur@npd.hcltech.com]
Sent: Friday, June 14, 2002 7:16 AM
To: ips@ece.cmu.edu
Subject: iSCSI: FirstBurstSize and unsolicited data


Hi All,

Consider the case where InitialR2T=yes and ImmediateData=yes.
All other values are the defaults.

The expected data transfer length for a SCSI write
operation is a value exceeding FirstBurstSize (64KB).

In the above case, the initiator will send immediate
unsolicited data (MaxRecvPDULength=8192 bytes).
After that it has to wait for an R2T from the target.

In this scenario, FirstBurstSize of data will not be sent
to the target as unsolicited data-out's cannot be sent here.

My understanding is that the remaining data can be
sent only through solicited Data-out PDUs,
and this is the expected way according to the draft.

What does the following statement(in Section 9.4.6.2 Sense Data) mean in
this context ?

<quote>

The target reports the "Not enough unsolicited data" condition only
if it does not support output (write) operations in which the total

data length is greater than FirstBurstSize, but the initiator sent

less than FirstBurstSize amount of unsolicited data, and out-of-order

R2Ts cannot be used.

</quote>

If this is specific to the SCSI layer at the target,
what is the dependency on FirstBurstSize?

Please clarify.

Thanks,
Nandakumar
Member Technical Staff
HCL Technologies, Chennai, INDIA.
http://san.hcltech.com